HP EML E-series Tape Libraries - Manual (Page 38)

Figure 32 OCP Status screen
Table 4 Status screen functions
Description Function
Contains basic configuration information. The library name, IPv4 address,
and IPv6 Interface Identifier are obtained from Command View TL. Other
information comes from the robot firmware. Identity Screen
The number of interface controllers and tape drives installed in the library
are listed, as well as the total number of available storage slots. For
example, load port slots configured as storage slots are counted in the
total of available slots, while load ports used to move tape cartridges in
and out of the library are not counted in the total.
This screen also shows the library model, library serial number, and library
firmware version.
Displays a status icon and health information for the library and individual
components: Health Summary
• Library and Robotics—Displays the health status of the library, robotics,
and each power supply in the library.
•
Load Ports—Provides the health status of each load port in the library.
• Drives—Provides the health status of each drive in the library.
•
Interface Controllers—Provides the health status of each Interface
Controller in the library.
• Interface Manager—Provides the health status of the library Interface
Manager.
Identifies the status of the overall library and individual components: Component Status
•
Library and Robotics Status—Displays library and robotics
characteristics, the tape drive odometer, the status of the load port
doors, and the status of the library sensors. The odometer counts the
number of loads for each tape drive. The load count is reset when a
tape drive is replaced.
•
Individual Drive Status—Displays detailed tape drive information for
each tape drive on individual screens. Select the Page Up and Page
Down tabs to move between available tape drives.
• All Drive Summary—Displays an overall status of all installed tape
drives and whether they contain tape cartridges.
•
Interface Controller Status—Displays the status for individual interface
controllers, showing the number of host ports, device ports, and
firmware revision.
•
Interface Manager Status—Displays health and configuration
characteristics of the Interface Manager card.
38 Using the library