Ag-Bag MB7010HyPac - Manual (Page 101)

9
S
ERVICE AND
M
AINTENANCE
STOP MACHINE AND TURN OFF ENGINE TO ADJUST
,
LUBRICATE
,
OR SERVICE
.
Ag-Bag International, Ltd.
MB7010 HyPac November 2003
Section 7
Anchor Cable Adjustment & Installation
Anchor Cable Adjustment
Most of the cable stretch will oc-
cur during the first bag, so ad-
justment needs to happen prior
to the second bag. Also check
each time the anchor are fully
retracted. The anchor must be
tight in the socket. To adjust fol-
low step 1 and then proceed to
step 4.
Anchor Cable Installation
1. Position the cylinder. Fully
extend the cylinder, then retract
1 inch. Shut off the tractor when
measuring.
2. Thread the cable through the
pulley system. Follow the letter
sequence in the illustration.
b. Over the fairlead.
c. Around the pulleys
d. Through the hole in the plate
e. Under the pulley.
Failure to maintain proper an-
chor adjustment may result in
cable damage, which may not be
covered by your warranty.
Serious injury may occur. Always
wear protective gloves while han-
dling wire rope cables
b
c d
e