Ag-Bag MB7010HyPac - Manual (Page 69)

S
ETUP AND
O
PERATING
P
ROCEDURES
19
Ag-Bag International, Ltd.
MB7010 HyPac November 2003
Section 4
I
NSTALLING
T
HE
A
G
-B
AG
® B
AG
1. Move the Ag-Bagger ® to the
position where you want the bag
to begin. Make sure you have
about 10’ of clear area behind the
tunnel.
2. Using the steering controls
on the center console move
the wheels into bagging posi-
tion, make sure that arrows
(1a) and (1b) align.
3. After moving the wheel make
sure the locking pin located be-
hind arrow (1b) is not in the
locked position as shown in fig.2.
4. Using the controls on the arm
rest console, lower feed table,
unlock and lift feed table wings
locking them into position.
Machine damage may occur.
Never attempt to turn wheel
while wheel lock pin is in the
locked position as indicated in
picture 3.
Locking Pin in unlocked posi-
tion. Locking Pin in locked position
2 3
4
a b 1
Crush Hazard Exists
Make sure area under feed
table is clear before lowering
the Feed Table.