Ag-Bag MB7010HyPac User Manual
Page 85
4
B
AGGING
AND
THE
T
ERRAIN
Ag-Bag International, Ltd.
MB7010 HyPac November 2003
Section 5
Leaving loose plastic
blowing in the wind
may cause product
loss. Secure both
ends of the bag after
sealing. Protect your
investment.
Remember, place bags
in a locations that feed
out can be done when
you need the feed.
B
AGGING
S
URFACE
Bag uphill rather than downhill. Avoid bagging on a side hill. The
Ag-Bagger
®
can drift and bags may roll.
Surface conditions may affect bagging quality and ability. Soft ground
conditions will act as a brake and may cause the Ag-Bagger
®
to
sink. A hard clean and level surface is best to bag on. By clearing
the area rodent problems can be eliminated.
B
AD
W
EATHER
B
AGS
Consider the surface conditions during the seasons when product
will be removed from the bags. If you expect a lot of mud, you may
want to put some bags on a solid surface. Have enough accessible
bags to last until good weather conditions can be expected.
P
ROTECT
A
GAINST
THE
W
IND
Winds blowing against the plastic can cause plastic fatigue. This
may create holes and allow oxygen into the bags. To prevent wind
damage secure the loose ends of the bag.
o
Pile old tires on the finished end of the bag after sealing.
o
Do no use abrasive materials or forage products, rodents
like this type of cover
Do not bag on a side hill.
Tip-over or bag roll may
result.