Ag-Bag MB7010HyPac User Manual
Page 64
S
ETUP
AND
O
PERATING
P
ROCEDURES
14
Ag-Bag International, Ltd.
MB7010 HyPac November 2003
Section 4
C
HECK
F
OR
H
YDRAULIC
L
EAKS
Checking for Hydraulic Leaks
Before starting engine and charging the hydraulic system do a slow walk around the Ag-Bagger
®
.
Inspect all hydraulic connections for any indications of fluid seepage. Using a clean dry rag wipe area
where there might be an indication of leakage. Remember to never place your hand over any hydraulic
hose, fitting or pipe while the engine is running and the hydraulic system is charged. Refer to the
Service and Maintenance section of this manual for the correct fluid to use in the hydraulic system.
S
TARTING
T
HE
E
NGINE
Serious injury or death my occur.
Make sure everyone is well clear of
any moving parts on the Ag-Bagger
®
before starting engine.
Starting the engine.
Before starting the engine make
sure everyone is away from any
moving parts of the Ag-Bagger
®
.
Review the correct starting pro-
cedures as outlined in the
Owner’s manual of the engine on
this machine. The manual was
supplied with the Ag-Bagger
®
when purchased.
C
HECK
F
OR
A
IR
L
EAKS
Serious injury may occur. Do not
use hands to check for air leaks.
High pressure air injections may
cause serious injury.
Check for air leaks.
After starting engine do a slow
walk around of the Ag-Bagger
®
,
using your ears, listen for an air
leak hissing sound. If you think
there is a leak use a solution of
water and soap from a squeeze
bottle to check. If you see
bubbles a leak exists. Shut down
the engine and tighten the fitting,
after tightening is complete start
engine and check fitting again.
Remember do not use you hand
of finger to check for air leaks.