Ag-Bag MB7010HyPac - Manual (Page 66)

S
ETUP AND
O
PERATING
P
ROCEDURES
16 Ag-Bag International, Ltd.
MB7010 HyPac November 2003
Section 4
1 2 2
4
5
3
The tunnel extension is stored
on the top of the tunnel. Use
the following procedure to in-
stall the tunnel on your Ag-Bag-
ger
® . (This procedure is best
accomplished by two people)
a. Attach the bag boom hitch
to the eye located on the cen-
ter of the tunnel extension. Fig
1.
b. Remove the hair pin and
locking pin from the tunnel ex-
tension located on the center
of the extension and the back
of the inoculant applicator
plate. Fig 2. This pin should be
reinstalled any time the Ag-
Bagger is transported.
c. Using the bag boom swing
the tunnel extension out and
lower to a position in front of
the tunnel. Position the exten-
sion where the pins on the ex-
tension (Fig 4.) line up with the
receiver holes (Fig. 3).
d. Use the three pins supplied
with your Ag-Bagger
® and
place them in the holes indi-
cated by Fig. 5. These pins are
located in the cab of your Ag-
Bagger
®
e. Fold the eye (Fig.1) back
onto the tunnel
T
UNNEL
E
XTENSION
- I
NSTALL
3