Ag-Bag MB7010HyPac - Manual (Page 102)

10
S
ERVICE AND
M
AINTENANCE
STOP MACHINE AND TURN OFF ENGINE TO ADJUST
,
LUBRICATE
,
OR SERVICE
.
Ag-Bag International, Ltd.
MB7010 HyPac November 2003
Section 7
Anchor Cable Adjustment & Installation (cont.)
3. Install the cable stop on the
cylinder end.
- Slide the cable (a) through the
sleeve (b).
- Unravel the cable (a) and wrap
around the knob core (c). Keep
the knob core halves flush.
- Tap the sleeve (b) down on to
the knob core (c) and cable (a)
with a hammer until secure.
4. Manually pull the cable tight
from the outside.
5. Mark both the cables in the
same spot as close to the fair
lead as possible.
6 Using the anchor cable out
switch on the arm console ex-
tend the cable 4 feet. Pull on the
cables while extending.
7. Cut the cable at the marks.
8. Slide the cable through center
of each anchor. Be sure to put
the anchor on nose first..
9. Install the cable stop as de-
scribe in item 3 above.
10. Pull on the anchor to secure
the cable stop in the nose of the
anchor.
11. Using the Anchor In/Out
switch on the arm rest console
retract the anchor. The anchors
should be tight in the sockets.
b
c
a
a. Cable
b. Sleeve
c. Knob Core
5. Mark Cable
Pull Tight