Ag-Bag MB7010HyPac - Manual (Page 56)

S
ETUP AND
O
PERATING
P
ROCEDURES
6 Ag-Bag International, Ltd.
MB7010 HyPac November 2003
Section 4
Locking Pin in unlocked posi-
tion. Locking Pin in locked position
W
HEEL
P
OSITION
Setting the wheel position is very
important in the operation of your
Ag-Bagger
® . Using controls 3
and 6 on the Center Console pic-
tured in this manual. Picture (A)
depicts the wheel controlled by
control 3 and picture (B) is con-
trolled by control 6.
Picture (A) shows the position-
ing of arrows 1,2, and 3 when the
wheel drive is in the towing or
moving position. Arrows 1 and 2
should be pointing towards each
other. Normally the wheel lock
pin will be in the position depicted
in picture (D) which is locked.
Picture (B) shows the position of
arrows 1, 2, and 3 when the
wheel drive is in the bagging po-
sition. Note that arrows 1 and 3
are pointing towards each other.
Normally the wheel lock pin will
be in the position depicted in pic-
ture (C) which is unlocked.
These indicators are located on
the wheel column located on the
rear of the machine on the en-
gine end. There is only one col-
umn that locks and it should be
locked any time you are towing.
Steering control of the Ag-Bag-
ger
® is done with the wheel on
the Cab end of the bagger.
Caution - Machine damage
may occur. Never attempt to
turn wheel while wheel lock
pin is in the locked position
as indicated in picture D.
A
C D
B
1 2 3
2
3
1