Ag-Bag MB7010HyPac - Manual (Page 72)

S
ETUP AND
O
PERATING
P
ROCEDURES
22 Ag-Bag International, Ltd.
MB7010 HyPac November 2003
Section 4
I
NSTALLING
T
HE
A
G
-B
AG
® B
AG
(
CONT
.)
11
12
Possibility of bag dam-
age. A minimum 3/4 inch
gap must remain be-
tween the tunnel and
bag pan.
11. Continue to raise the bag and
rotate it toward the tunnel pulling
the sides of the bag out to fit
around the tunnel extension. Pick
up the lower part of the bag and
place it into the bag pan making
sure it is laying flat in the bag pan.
When this is done move the bag
back and set the cradle down
onto the tunnel. Do not rest the
bag on the extension.
Remove all the tape or ropes that
hold the bag folds together.
12. Recheck and make sure all
tape and ropes have been re-
moved from the bag. Using the
control 8a close the bag pan un-
til there is approximately 3/4
clearance between the bag pan
and tunnel.
Using the bungee cord supplied
with the Ag-Bagger
® stretch it
across the top of the tunnel and
place the hooks into the holes
drilled in the bag pan.
Locate the three hooks located
at the back of the tunnel and tie
strings to the bungee cord and
attach it to these hooks. This
keeps the bungee from moving.
Note: The Ag-Bagger ® used for
these photos is not the MB7010
but the procedures are the same.