Ag-Bag MB7010HyPac - Manual (Page 58)

S
ETUP AND
O
PERATING
P
ROCEDURES
8 Ag-Bag International, Ltd.
MB7010 HyPac November 2003
Section 4
A
RM
R
EST
C
ONTROLS
(
CONT
.)
4 3
2 1
5 6
7
8
9
10
11
12
13
14
15
16
8. Mode Switch: Press
switch to access the pre-pro-
gramed speed of 1800 RPM.
This is the best speed for hay.
9. Anchor Float Switch:
Turn OFF during the bagging
operation. Turn ON to allow
the anchors to float out.
10. Anchor In/Out Switch:
Press the top of the switch (IN)
to power anchors into the tun-
nel. Press the bottom of the
switch (OUT) to power an-
chors away from the tunnel.
Watch the anchor scale for
position of the anchors.
11. Feed Table Switch: Press
top of the switch to raise the
feed table. Press the bottom
of the switch to lower the feed
table. Make sure you watch the
feed table during this operation
to make sure it is not moving
up or down to quickly, damage
can be done if the table hits to
hard.
12. Tunnel Clean Out
Switch: The top of the switch
operates the out/open position.
The Bottom of the switch is the
in/closed position.
Machine Damage
Stop Rotor before activating
the Tunnel Clean Out. The red
warning light on the front con-
sole will go off when the tun-
nel clean out is completely
closed. Never activate the ro-
tor with the Tunnel Clean Out