Operating safety – State 520 User Manual

Page 34

Advertising
background image

Operating Safety 

34

Page

 

OPERATING SAFETY

FOR YOUR SAFETY READ BEFORE OPERATING 

WARNING: If you do not follow these instructions exactly, a fire or explosion may result 
causing property damage, personal injury or loss of life. 

A. This  water  heater  does  not  have  a  pilot.  It  is  equipped  with  an  ignition  device  that 

automatically lights the burner. Do not try to light the burner by hand. 

B. BEFORE  OPERATING  smell  all  around  the  water  heater  area  for  evidence  of  leaking 

gas. Be sure to smell next to the floor because some gas is heavier than air and will 
settle on the floor. 
WHAT TO DO IF YOU SMELL GAS. 

 Do not try to light any appliance. 

 Do not touch any electric switch, do not use any phone in your building. 

 Immediately  call  your  gas  supplier  from  a  neighbor's  phone.  Follow  the  gas 

supplier's instructions. 

 If you cannot reach your gas supplier, call the fire department. 

C. Use only your hand to turn the gas valve knob. Never use tools. If the knob will not 

turn  by  hand,  don't  try  to  repair  it.  Call  a  qualified  service  technician.  Forced  or 

attempted repair may result in a fire of explosion. 

D. Do  not  use  this  water  heater  if  any  part  has  been  under  water.  Immediately  call  a 

qualified service technician to inspect the water heater and to replace any damaged 

parts.

OPERATING INSTRUCTIONS 

1. STOP! Read the safety information above or in the Owners Manual. 
2. Turn off all electric power to the water heater. 
3. Do not attempt to light the burner by hand. 
4. Turn the manual gas valve located on the outside of the unit clockwise 

↻ to the off 

position. 

5. Wait five (5) minutes to clear out any gas. If you then smell gas. STOP! Follow "B" in 

the safety information above on this label. If you don't smell gas, go to next step. 

6. Turn the manual gas valve located on the outside of the unit counter clockwise 

↺ to 

the ON position. 

7. Turn on all electrical power to the water heater. 
8. If the water heater will not operate, follow the instructions “to Turn Off Gas to water 

heater" and Call your service technician or gas supplier.

TO TURN OFF GAS TO APPLIANCE 

1.

Turn off all electric power to the water heater if service is to be performed. 

2.

Turn the manual gas valve located on the outside of the unit clockwise 

↻ to the off position.

O

O

O

w

w

w

n

n

n

e

e

e

r

r

r

s

s

s

G

G

G

u

u

u

i

i

i

d

d

d

e

e

e

Advertising
This manual is related to the following products:

320