Vaisala HMW90 - Manual (Page 82)

User's Guide _______________________________________________________________________
80 ___________________________________________________________________ M211399EN-F
1209-028
Figure 33 DIP Switches in Factory Reset Position (HMW95)
4. Reconnect the transmitter cover to the mounting base so it powers
up. Check the screen after power-up: when the DIP switches are in
factory reset position, you will see a notification text.
5. Disconnect the transmitter cover again.
6. Set the DIP switches to the positions they were before.
7. Reconnect the transmitter cover to the mounting base. Check the
startup screens to verify the configuration.
Reverting to Factory Settings Using
Service Port
Use the FRESTORE command to restore the transmitter to factory
settings.
FRESTORE<cr>
NOTE After using the FRESTORE command, reset the transmitter using the
RESET command.
Example:
>pass 9000
>frestore
Restoring HTM10 factory parameters
HTM10 factory parameters restored
Restoring HMW93 factory settings
72/72 parameters restored
OK
>reset
Resetting
HMW93 / 1.00.00.0000 / XM90
>
HMW95
1
ON
2 3 4 5 6 7 8
Modbus
BACnet
Parity Even
A B C
Parity None
Baud
Rate Metric
Non-Metric