Front panel, Craft port – ADTRAN 4200659L1 User Manual
Page 40
Chapter 2. Installation and Operation
2-10
MX2800 User Manual
61200659L1-1
FRONT PANEL
The MX2800 STS-1 faceplate is shown below in Figure 2-4.
Descriptions of each part of the front panel follow.
Figure 2-4. MX2800 STS-1 Front Panel
Craft Port
The
CRAFT
port, an 8-pin modular jack, provides connection to a
VT-100 EIA-232 compatible interface using the supplied 8-pin
modular to DB-9 female connector and the 8-pin to 8-pin modular
cable.
Establishing Terminal Connection
To connect the MX2800 STS-1 to a VT-100 terminal, follow the
steps below:
1. Configure the VT-100 terminal for 9600, 19200, 38400, or
57600 baud, 8-bit characters, no parity, and one stop bit (xxxx,
8N1).
2. Using the terminal interface cable adapter provided by
ADTRAN, connect the DTE port of a terminal to the 8-pin
modular jack labeled
CRAFT
on the MX2800 STS-1 front
panel.
3. Initialize the terminal session.
4. Press
Enter
repeatedly until the password prompt appears.
5. Enter the password. The factory default password is
adtran
(all
lower-case). The
M
AIN
M
ENU
appears (see Figure 2-5 on page
A
C
T
N
E
T
A
L
M
P
R
F