Agilent Technologies E4438C - Manual (Page 12)

Getting Started
Overview of Getting Started
1-2
Overview of Getting Started
Agilent’s service support software allows fast and accurate testing of the Agilent E4438C ESG vector signal
generator. This chapter describes how to install, configure, and run service support software so that you can
adjust and test an Agilent E4438C ESG vector signal generator to meet specifications.
How to Proceed
First, review the rest of this section to learn about installing, configuring, and running service support
software. Next, refer to “Required Equipment” to learn about hardware and software requirements, or become
familiar with “Performance Tests” or “Adjustments”. If you need assistance, refer to the section on
“Contacting Agilent Technologies” on page 5-1 .
To install, configure, and run this software, refer to and perform the steps in the following procedures:
1. “Confirming Equipment” on page 1-3
2. “Installing Service Support Software” on page 1-4
3. “Administering Service Support Software” on page 1-8
4. “Running Service Support Software” on page 1-22