Agilent Technologies E4438C - Manual (Page 19)

Getting Started
Administration of Service Support Software
1- 9
5. Select the OK button.
6. The Select Test Equipment and Tests window appears on the display. Close this window.
Adding Test Equipment
Before any performance tests can be run, information regarding your specific test equipment must be entered
into the software’s database. This information includes the serial numbers, calibration dates, GPIB address,
and traceability data for each individual component. Only equipment which has been entered into the system
will be available for the test equipment selection process during the test setup. To add test equipment, follow
the instructions below:
1. Refer to Figure 1-2 . In the File drop-down menu, select Test Equipment.
Figure 1-2 Test Equipment in the File Drop-Down Menu
2. Refer to Figure 1-3 . In the Test Equipment dialog box, select the Device Type for the new equipment you
are adding.