Agilent Technologies E4438C - Manual (Page 14)

Getting Started
Installing Service Support Software
1-4
Installing Service Support Software
NOTE If you are installing service support software onto a computer which already has service
support software older than version A.03.00, the old version must be removed before installing
the new version.
To install service support software into a PC:
1. Insert “Disk 1” into the disk drive.
2. Display the Run dialog box:
• For MS Windows 95 or Windows NT: Select the Start button, then select Run... from the pop-up menu.
• For MS Windows version 3.x: Open the Program Manager, then select Run ... from the File drop-down
menu.
3. From the Run dialog box, type a:setup and select the OK button.
The Setup window is displayed as it loads files for the installation.
Once these files are loaded, the ESG Service Software’s Welcome screen is displayed.
4. Continue with the setup by selecting the Next button.
5. The ESG Service Software’s Important Information window is displayed. It contains information that is
vital to installing and using the software. In addition, any new information may also be shown on this
screen. Stop and read this information before continuing with the software installation!
6. Continue with the setup by selecting the Next button.
The Choose Destination Location window is displayed. The default location for installing the software is
C:\HP_SVC\ESG_C. Use this as the software’s destination folder.
7. Continue with the setup by selecting the Next button.
The ESG Service Software’s Select Program Folder window is displayed. This installation procedure will
install the service software icons into a program folder. You can enter a new folder name in the Program
Folders text field or select a folder from the Existing Folders field. It is recommended to use “ESG_C
Service Software” for the folder name.
NOTE This documentation refers to the folder name as “ESG_C Service Software.” If you use another
name for the folder, be aware of this difference.
8. Continue with the setup by selecting the Next button.
The ESG Service Software’s Start Copying Files window is displayed. This window shows the destination
directory and the folder name settings. To change these settings, select the Back button until the
appropriate window is displayed.
NOTE This is the last point that you can cancel the installation. If you select the Next button, the
installation proceeds until the software is completely installed.
9. Select the Next button to go ahead with the installation process.
The graphic on the left of the screen shows the status of each file as it is copied to the destination directory,