ARRI WRC-1 - Manual (Page 104)

104
5.7 Controlling the camera speed
5.7.1 Speed / compensation off
The camera speed can be manually adjusted within the
pre-defined end-stops of the handwheel.
Differences in exposure are not automatically
compensated for.
The main menu shows ‘SPEED’ in the first display line,
and the currently adjusted camera speed in the second
display line.
By pressing the SET button, the currently set shutter angle
(if controlled by the WRC-1) can be shown in the first
display line and the currently set T-stop (if controlled by
the WRC-1) is shown in the second display line.
Note The following warnings may be displayed:
‘IRIS TBL’ – a valid iris table has not yet been
activated;
readings with ‘NO’ in the first display line
indicate that the selected function is currently
not available (example: ‘NO IRIS’ although the
iris control is activated on the WRC-1, the iris
motor has not yet been connected);
readings with ‘RANGE’ in the second display
line indicate that the adjustment range of a
parameter has been exceeded (example: the
selected speed is not available with this camera);
readings with ‘OFF’ in the first display line
indicate that this function is deactivated on the
camera (example: shutter angle of the 435 is
set manually = ‘OFF ANGLE’).
Correct parameters must be set before the
camera is started!
• Press the MODE button in the main menu to enter the
first submenu. The end-stops for the handwheel (mini-
mum and maximum camera speed) can be defined.
The first display line shows the value for the left
handwheel end-stop, the second line shows the value
for the right end-stop.
Controlling the Camera Speed