ARRI WRC-1 - Manual (Page 122)

122
• Press the MODE button in the main menu to enter the
first submenu. The limit values for the left and right
end-stop of the handwheel (minimum and maximum
camera speed) can be defined.
The first display line shows the value for the left end-stop,
the second line shows the value for the right end-stop.
• Press the SEL button for longer than 2 seconds.
The first digits in the first display line flash. The required
value can now be set using the handwheel. Press the
SEL button again to switch to the next digit. The first
digits are confirmed, and the decimal positions are set
to ‘0’ by pressing the SET button. The values in the
second display line can be set accordingly.
• Press the MODE button to go to the next submenu. The
limit values for the mirror shutter angle can be defined.
Both the mirror shutter angle and the aperture of the
lens (if necessary) are automatically adjusted to
compensate the exposure while the camera speed is
adjusted with the handwheel.
The two limit values (minimum and maximum shutter
angle) can be selected as required.
Press the SEL button for longer than 2 seconds.
The shutter angle shown in the first display line
flashes. This can now be set using the handwheel.
Press the SEL button again to switch to the next digit.
The first digits are confirmed, and the decimal is set to
‘0’ by pressing the SET button. The values in the
second display line can be set accordingly.
The first display line shows the value for the left
handwheel end-stop, the second line shows the value
for the right end-stop.
If the compensation range available with the
aperture is exceeded (e.g. the start value is at
the beginning or end of the adjustment range)
the READY LED flashes green and the warning
‘IRIS RANGE’ flashes on the display after
returning to the main menu.
The limit values for the shutter angle, the iris or
the camera speed must be corrected! The
Controlling the Camera Speed