ARRI WRC-1 - Manual (Page 44)

44
5.5.1.2 Programming an iris table
for other lenses
(‘TBL EDIT’)
• If ‘IRIS TBL’ flashes on the display when the WRC-1 is
switched on, the MODE button must be pressed once
to enter the ‘TBL LOAD’ mode.
If a lens has already been selected and the T-stops
have been assigned previously, the menu for selecting
the lens can be entered in the WRC rotary switch
position ‘IRIS’ and the COMPENSATION rotary switch
set to ‘OFF’ by pressing the MODE button three times.
The values for the last lens used may still be stored
and active in the WRC-1. All settings and the
active iris table should therefore always be
checked in order to avoid incorrect exposures!
• To delete an old assignement (iris table), turn the
handwheel until ‘DEL’ is shown in the second line of
the display. Then press the SEL button. ‘TBL’ flashes in
the first line. Press the SET button to finally delete the
old assignement. ‘DONE’ is shown on the display for
one second.
Controlling the Iris