ARRI WRC-1 - Manual (Page 172)

172
OFF ON
IRIS
RAMP SET/ SEL/ MODE OPEN
RUN CAM WRC READY
PHASE
,Iris
WRC-1
fps,
Iris
user
max
max
Iris
50%
Iris off
Iris
fps
fps ramp
ramp
ramp Iris
PROG
compen
sation
W
RC
7.2 Basic operating modes
7.2.1 CAM mode
Set the WRC/CAM sliding switch to CAM. In this operating
mode the display on the WRC-1 is identical to the camera
display. The settings on the camera can be adjusted by
pressing the MODE, SEL and SET buttons. The OPEN
button serves as the PHASE button on the camera.
7.2.2 WRC mode
Set the WRC/CAM sliding switch to WRC. This mode
provides access to advanced remote control options,
which allow different ramps to be programmed with the
corresponding exposure compensation options.
IRIS ON/OFF
The IRIS sliding switch is used when switching on the
WRC-1 to determine whether the WRC-1 should control
the iris motor (IRIS ‘ON’) or not.
As the T-stops on the ARRIMACROS change when the
lens is focussed, the ARRIMACROS may not be used with
the LCS or the WRC-1 system.
WRC/CAM sliding switch
WRC
rotary switch
IRIS sliding switch
SET button
RAMP button
SEL button
MODE button
OPEN/PHASE
button
handwheel
COMPENSATION
rotary switch
Quick Guide