ARRI WRC-1 - Manual (Page 49)

49
m
ft
h:min
TC UB
fps
end
sec:f bat
3 1 2 4
8 7 6 5
PROG
asy
j am
filter
R
The WRC-1 is not able to check whether the
selected user-defined iris table is actually
compatible with the lens being used. An error
message can only be displayed if the iris motor
reaches the end-stops of the lens during cali-
bration, and these had been positioned else-
where while the lens was being programmed.
• If the wrong iris table has been unintentionally selected
(e.g. by choosing the wrong memory area), and the
iris motor strikes unexpected end-stops during the
calibration process, the warning ‘LENS ERROR’ is
displayed. Press the SEL or SET button to go to the
mode for assigning the T-stops. The current T-stops can
be reassigned.
CAL button
Controlling the Iris