ARRI WRC-1 - Manual (Page 25)

25
5. Operation
5.1 Operating modes
5.1.1 CAM mode
The operating elements of the WRC-1 control the same
functions as the corresponding elements on the camera:
MODE, SEL, SET, and the RUN LED. In CAM mode, the
OPEN button corresponds to the PHASE button on the camera.
The RAMP button corresponds to the PROG button on the
camera. The handwheel and the WRC- and COMPENSATION
rotary switches are without function in this operating mode.
• All functions are comprehensively described in the
camera instruction manuals and are not repeated.
The display of the WRC-1 shows the same information as
the camera display in this operating mode.
Note: If the WRC-1 is only to be used in this operating
mode, it is advisable to set the WRC/CAM
sliding switch to CAM before the WRC-1 is
switched on. This ensures that the set frame rate
or a programmed shutter angle in the camera’s
PS/CCU mode and the WRC-1 in WRC mode
is not unintentionally altered.
In WRC mode the WRC-1 overwrites the
camera’s shutter angle and speed settings
(see Important instructions).
Camera programs which have been stored in
the camera via the CCU or the LCC are not
affected.
Forward or reverse run is set in the same way as on the
camera itself.
Note: With the ARRIFLEX 535 forward or reverse run is
set in the same way as on the ARRIFLEX 535B,
435, 16SR 3/Advanced.
Operation