Alvarion BREEZEACCESS SW VERSION 5.1 - Manual (Page 210)

Chapter 4 - Operation and Administration
BreezeACCESS VL System Manual
178
4.2.6.4.2.2 DHCP Broadcast Override Filter
The DHCP Broadcast Override Filter option enables or disables the broadcasting
of DHCP messages. Even if according to the selected option in the Filter Options
parameter, broadcast messages should be filtered, DHCP broadcasts are
transmitted if this parameter is set to Enable. Select from the following options:
„ Disable - DHCP Broadcast messages are filtered or transmitted according to
the general filtering criteria in the Filter Options parameter.
„ Enable - DHCP Broadcast messages are transmitted regardless of the selected
value of the Filter Options parameter.
The default selection is Disable.
4.2.6.4.2.3 PPPoE Broadcast Override Filter
The PPPoE Broadcast Override Filter option enables or disables the broadcasting
of PPPoE (Point to Point Protocol over Ethernet) messages. Even if according to
the selected option in the Filter Options parameter, broadcast messages should
be filtered, PPPoE broadcasts are transmitted if this parameter is set to Enable.
Select from the following options:
„ Disable - PPPoE Broadcast messages are filtered or transmitted according to
the general filtering criteria in the Filter Options parameter.
„ Enable - PPPoE Broadcast messages are transmitted regardless of the
selected value of the Filter Options parameter.
The default selection is Disable.
4.2.6.4.2.4 ARP Broadcast Override Filter
The ARP Broadcast Override Filter option enables or disables the broadcasting of
ARP messages. Even if according to the selected option in the Filter Options
parameter, broadcast messages should be filtered, ARP broadcasts are
transmitted if this parameter is set to Enable. Select from the following options:
„ Disable - ARP messages are filtered or transmitted according to the general
filtering criteria in the Filter Options parameter.
„ Enable - ARP messages are transmitted regardless of the selected value of the
Filter Options parameter.
The default selection is Enable.