Alvarion BREEZEACCESS SW VERSION 5.1 - Manual (Page 89)

Installing the SU-I
Installation
57
3
Connect the RF cable supplied with the antenna to the SMA jack located on
the unit’s front panel. Install the antenna using the instructions provided in
Section
2.5.5 on page 57, and connect to it the other end of the RF cable. Do
not over-tighten the SMA connectors.
4
If parameters are not pre-configured, configure the basic parameters as
described in Section 3.1.
5
Align the antenna as described in Section 3.3.
6
Connect the 10/100 Base-T Ethernet connector to the data equipment. The
cable connection should be a crossed Ethernet if connecting to a hub/switch
and a straight cable if connecting directly to a PC Network Interface Card
(NIC).
7
Verify proper operation of the Ethernet link (see Table 2-5 for the Ethernet
activity LED indication). To verify data connectivity from the end-user's PC or
from a portable PC connected to the unit, ping a known device in the network,
or try connecting to the Internet.
2.5.5 Installing the Detached Antenna
The detached antenna kit includes the following components:
„ ALA04-200160 panel antenna
„ 2 meter SMA-SMA (M/M) RF cable
„ Simple wall mounting kit, enabling installation on a wall (without any
capability for adjusting the direction). For installation instructions see
Section
0 .
„ Wall mounting kit with rotation capability, enabling installation on a wall with
capability for adjusting the direction. For installation instructions see Section
2.5.5.2 .
„ Simple window mounting accessories, enabling installation on a glass window
(without any capability for adjusting the direction). For installation
instructions see Section
2.5.5.3 .
„ Window mounting kit with rotation capability, enabling installation on a glass
window (with rotation capability for adjusting the direction). For installation
instructions see Section
2.5.5.4 .