Alvarion BREEZEACCESS SW VERSION 5.1 - Manual (Page 252)

Appendix C - Using the Set Factory Defaults Utility
BreezeACCESS VL System Manual
220
The Set Factory Defaults utility is intended to enable management access to a
unit in cases where such access is not possible due to wrong or unknown
configuration of certain parameters. This includes cases such as unknown
Management VLAN ID and wrong management access filtering.
The utility accesses the unit by sending a special packet. Access to the unit is
based on its MAC address, which must be entered in the Unit MAC address field.
The set unit defaults feature is only available via the Ethernet port.
To set factory defaults:
1
Connect the PC with the Set Factory Defaults utility to the Ethernet port of
the unit.
2
Enter the unit’s MAC address.
3
Click on the Set button.
This utility performs the same operation as Set Complete Factory Defaults,
restoring the default factory configuration of all parameters, except to Passwords,
general FTP parameters and AU’s Frequency.