Alvarion BREEZEACCESS SW VERSION 5.1 - Manual (Page 69)

Installation Requirements
Installation
37
Table 2-3: Access Unit ODU Types
AU ODU Type Description
AU-E-ODU (all bands
except 0.9 GHz)
A rectangular enclosure (30.5 x 11.7 x 5.7 cm) with a connection
to an external antenna (not included). Not available in the 0.9
GHz band. HW revision D or lower.
New AU-E-ODU
(0.9 GHz units only)
A diamond shaped enclosure (22 x 22 x 7 cm) with a connection
to an external antenna (not included). The smaller size new AU-E-
ODU (HW revision F) is currently available only in the 0.9 GHz
band.
„ Pole mounting kit for the AU-ODU (the kit for the new, smaller-size ODU is
different from the kit for all other ODUs)
„ RF cable
2.1.1.4 Optional Items Available from Alvarion
„ IDU to ODU Category 5 Ethernet cable with a shielded RJ-45 connector
crimped on one end and two shielded RJ-45 connectors (available in different
lengths. For more details refer to section
2.1.2 )
„ Tilt Pole Mounting kit for the new, smaller size ODU.
„ A Y-cable for connecting directly to the IDU COM of ODUs with a new (smaller
size) enclosure for configuration/performance monitoring using a portable PC.
2.1.1.5 Additional Installation Requirements
The following items are also required to install the BreezeACCESS VL system
components:
„ Ethernet cable (straight for connecting to a hub/switch etc., crossed for
connecting directly to a PC’s NIC)
„ Crimping tool for RJ-45 connectors
„ Antenna, for E model units supplied without an antenna
„ Ground cables with an appropriate termination