Alvarion BREEZEACCESS SW VERSION 5.1 - Manual (Page 242)

Chapter 4 - Operation and Administration
BreezeACCESS VL System Manual
210
4.2.6.8 Country Code Parameters
4.2.6.8.1 Country Code Select
The Country Code Select option enables changing the Country Code used by the
unit. In the current release this option is applicable only to units in the 5.4 and
5.8 GHz bands.
The default Country Code is set in factory according to the destination country.
CAUTION
The selected Country Code must comply with applicable local radio regulations.
4.2.6.8.2 Re-apply Country Code Values
After loading a new SW version with any changes in the relevant Country Code,
the Re-apply Country Code Values option must be activated for the changes to
take effect. Following activation of this feature, the unit must be reset to fully
apply the changes.
NOTE
Following activation of the Re-apply Country Code Values option, all parameters that are affected
by the Country Code (frequency parameters, transmit power parameters, DFS operation,
modulation level parameters, burst mode parameters) revert to their factory default values and
must be re-configured.