Kramer Electronics WP-501 - Manual (Page 118)

K-Config – Adding Actions to a Trigger 113
9.10 Site Control Message
The Site Control Message action is used to send messages to Site-CTRL and display them.
Select the Port, the Query and the Status. If relevant, the status is set so that it fits the Site Control filtering
categories. The message is typed as required.
For example, in case of a communication error query, a message is sent to Site-CTRL.
To set the Site Control Message command:
1. Select the communication error query:
Figure 203: Site Control Message – Select the Query Event
2. In the Action Editor, select Site Control Message:
Figure 204: Site Control Message – Action Group Trigger is added to an Event trigger
3. Select the Port and Query: