Kramer Electronics WP-501 - Manual (Page 62)

K-Config – Defining the Control Room via the Project Navigator 57
Select the SL-14RC buttons you want to copy and click OK.
For the RC-13TC use the "Set Automatic
Behavior” to create automatic triggers and actions after defining
the port manager:
The Device Transport Commands Wizard window below shows the devices connected to the RC-13TC
ports:
Click OK.
By clicking OK, triggers and actions are automatically created that assign a transport command to the
appropriate button on the RC-13TC.
The following example shows the automatic triggers and actions created for a projector:
Each button on the RC-13TC represents a button on that projector.
Note that you can add or delete actions in the trigger