Kramer Electronics WP-501 - Manual (Page 129)

124 K-Config - Connecting to the Device
Figure 223: Firmware Upgrade Successful
9. Click OK.
Note that you might be asked to restart the unit.
Figure 224: Firmware Upgrade Process Complete
10. Upon completion, open the Device Settings window to make sure the firmware was upgraded.
If the firmware number remains the same, close the Device Properties windows, disconnect and then
reconnect the device, and open the Device Properties window again to check the Firmware number.
Device setting readout is possible with standalone room controllers and K-NET Master RC or Aux K-NET devices
connected with a K-NET cable to their Master RC, as defined in the Room Control tree.
10.4 Device Settings Window
The Device Settings window reads the data from the connected machine.
1. Click the Connect button on the main window or select Connect from the Device menu.
The Connect window appears (see Figure 37 ).
2. Select the connection method to the standalone controller or Master RC and click the Connect button (in the
Connection Method Window).
Device setting readout is possible with standalone room controllers and K-NET Master RC or Aux
K-NET devices connected with a K-NET cable to their Master RC, as defined in the Room Control tree.
i
i