Kramer Electronics WP-501 - Manual (Page 2)

K-Config – Contents i
Contents
1 Introduction 1
1.1 Overview 1
1.2 System requirements: 2
2 Planning the Controlled Room 3
2.1 Glossary 3
3 Kramer K-Config Software Installation 4
3.1 Installing the “.NET Framework” Revision 2.0 Software 4
3.2 Installing the USB Driver 4
3.3 Installing Kramer K-Config Software 8
4 Getting to Know K-Config 10
4.1 Initially Importing the Drivers 11
4.2 The Main Window 13
4.3 The K-Config Menus 17
4.4 Quick Access Icons 23
5 The Driver Manager – Getting Started 24
5.1 Getting to Know the Driver Manager 24
5.2 Selecting the Driver Manager 27
5.3 The Commands Tree Editor (Commands Hierarchy) 30
5.4 Setting the Shared Commands 33
5.5 Serial Commands 36
6 Defining the Control Room via the Project Navigator 52
6.1 The Virtual Device 58
7 Assigning the Peripheral Devices to Master and Auxiliary Device Ports 62
7.1 Assigning a Peripheral Device Driver to an RS-232 / RS-485 / IR Port 64
7.2 Setting the Functionality of the GPI/O Port 67
7.3 Assigning a Peripheral Device Driver to an Ethernet Port 69
8 Using the Triggers 72
8.1 The Custom Events 73
8.2 Keypad Events 76
8.3 Monitor Events 80
8.4 GPI/O Events 81
8.5 Timer Events 83
8.6 Query Events 91
8.7 Sub Routines 95
9 Adding Actions to a Trigger 98
9.1 General Instructions 99
9.2 Adding a Port Command 100
9.3 Adding a Port Switch Action 103
9.4 Adding a Panels Status Action 104
9.5 Adding a Switcher Command 111
9.6 Adding a Power Amplifier 111
9.7 Timer Start/Stop 112
9.8 Delay 112
9.9 Adding Sub Routines 112
9.10 Site Control Message 113
10 Connecting to the Device 116
10.1 Connecting Methods 116
10.2 Set the K-NET IDs 120
10.3 Firmware Upgrade 122
10.4 Device Settings Window 124
10.5 Syncing the Configuration to the Device 129
10.6 Reading the Configuration from the Device 130
10.7 Clear Configuration from Device 131
Figures
Figure 1: Media Room Components List 3
Figure 2: USB Driver Installation –USB Installation Attempt 4
Figure 3: USB Driver Installation – Select USB Driver Properties 5
Figure 4: USB Driver Installation –USB Driver Properties Window 5
Figure 5: USB Driver Installation – USB Driver Update 6
Figure 6: USB Driver Installation – USB Driver Location 6
Figure 7: USB Driver Installation – Windows Security 7
Figure 8: USB Driver Installation – USB Driver Updated 7
Figure 9: USB Driver Installation –USB Recognized on PC 8
Figure 10: Setting a Working Directory 8
Figure 11: Change the Working Directory Window 9
Figure 12: Drive Database Loaded 9
Figure 13: Installation Complete 9
Figure 14: Opening K-Config 10
Figure 15: Driver Database Notice 10
Figure 16: Devices XMLs Notice 11