Kramer Electronics WP-501 - Manual (Page 122)

K-Config – Connecting to the Device 117
To connect a device:
1. Click the Connect button in the quick access toolbar.
You can also select Connect from the Device menu
Figure 208: Connection Method Window
2. Select the Connection Method (Ethernet, Serial or USB).
3. Enter the data that is relevant to the selected connection method:
 UDP – the device IP number and the port number
Click Default to return to the default IP number ( Section 10.1.1 )
 TCP – the device IP number and the port number (note that you have to set the port number to 50000)
Click Default to return to the default IP number ( Section 10.1.1 )
 Serial – select the port number to which the device is connected and set the baud rate ( Section 10.1.2 )
 USB – select the USB port to which the device is connected
Click refresh ports if a new port was added ( Section 10.1.3 )
If the project navigator room configuration does not reflect the actual controlled room, the following warning appears:
Figure 209: Configuration Mismatch Warning
10.1.1 Connecting via the Ethernet
To connect via the Ethernet (UDP + TCP)
1. Set your PC to enable Ethernet connection (see Section 10.1.1.1 ).
2. Type the device IP number.
3. For TCP only, set the port number to 50000
4. Click Connect.