6 reading the configuration from the device, Reading the configuration from the device, Figure 232: write configuration warning – Kramer Electronics WP-501 User Manual
Page 135: Figure 233: writing and device resetting process, Figure 234: writing complete
130
K-Config - Connecting to the Device
Figure 232: Write Configuration warning
Note that during the Sync process, K-Config writes the current configuration and saves (to its current
project name) it as well.
5.
Click OK.
The Writing process appears on the top left part of the main window. After uploading the device resets
Figure 233: Writing and Device Resetting Process
6.
Upon completion, the following window appears:
Figure 234: Writing Complete
7.
Click OK.
10.6
Reading the Configuration from the Device
In order to read the Device configuration you have to add the system setup in the Project Navigator window. Note that
you cannot read the device configuration via the USB port.
1.
Connect the PC to the Master or the standalone room controller.
2.
Click the Connect button (or select Connect from the Device menu list).
3.
In the Device menu, select Read Configuration from Device.
The following message appears:
i