Kramer Electronics WP-501 - Manual (Page 48)

K-Config – The Driver Manager – Getting Started 43
Figure 74: IR Commands – The IR command String Obtained
9. Click Set to save the command.
You can test the IR command by connecting the RC unit IR terminal block connectors to the device via the IR emitter,
and then clicking the Test Command button.
Figure 75 shows how to connect the IR emitter (Using the Kramer 3.5mm to IR Emitter Control Cable (C-A35/IRE-10)).
The white striped side connects to IR OUT, the black side connects to the Ground, and the LED Emitter Shell is affixed
to the IR sensor window with the adhesive layer.
Figure 75: IR Emitter Wiring
The dual IR emitter emits a weaker IR signal that may not be detected by some devices.
5.5.3 Creating a Serial Reply
When sending a serial command to a device, that device will usually send a reply. This reply can be used to create
monitor events. Serial replies can be typed manually or by sending a serial command to the device and obtaining its
reply.
To add a serial reply:
1. Select a command for which there is a command string in the serial command, for example PWR_OFF.
2. In Serial Reply, select PWR_OFF from the shared list:
i