Kramer Electronics WP-501 - Manual (Page 5)

iv K-Config – Contents
Figure 177: The Action Editor 99
Figure 178: Selecting the Port Command Action Type 100
Figure 179: Selecting the Command 100
Figure 180: The New Command in the Action List 101
Figure 181: The Action List for the All On Trigger 101
Figure 182: The All On Trigger (after adding commands to the action list) 101
Figure 183: The Table Port Command 102
Figure 184: The Table Port Command – Setting a specific Volume Level 102
Figure 185: The Table Port Command – Added to the Action List 103
Figure 186: Selecting the Port Switch Action Type 103
Figure 187: Port Switch Action Type added to the Action List 103
Figure 188: Panels Status Action Editor 104
Figure 189: Panels Status Action List 105
Figure 190: Panels Status Action List Names 105
Figure 191: Panels Status – Selecting a Button 106
Figure 192: Panels Status – Selecting a Button 106
Figure 193: Panels Status – Button Color and Behavior Selected 107
Figure 194: Panels Status – Setting the LCD Label 108
Figure 195: Panels Status –LCD Label Added 108
Figure 196: Panel Status – LEDs Light States 109
Figure 197: Panel Status – Panel Lock 110
Figure 198: Panel Status – Locking the Front Panel Buttons 110
Figure 199: Switcher Command – Select an Input 111
Figure 200: Power Amplifier – Select an input 111
Figure 201: Delay – Set the Delay Time 112
Figure 202: Sub Routines – Select a Sub Routine 112
Figure 203: Site Control Message – Select the Query Event 113
Figure 204: Site Control Message – Action Group Trigger is added to an Event trigger 113
Figure 205: Site Control Message – Select Port and Query 114
Figure 206: Site Control Message – Select the Status 114
Figure 207: Site Control Message – Type the Message 115
Figure 208: Connection Method Window 117
Figure 209: Configuration Mismatch Warning 117
Figure 210: Local Area Connection Properties Window 118
Figure 211: Internet Protocol Version 4 Properties Window 119
Figure 212: Internet Protocol Version 6 Properties Window 119
Figure 213: Internet Protocol Properties Window 120
Figure 214: KNET ID – A Controlled Room Setting Example 121
Figure 215: KNET ID – Connect the Device Directly to PC 121
Figure 216: KNET ID – The K-NET ID Connect Window 121
Figure 217: KNET ID – Setting K-NET ID 122
Figure 218: KNET ID –K-NET ID assigned 122
Figure 219: Firmware Update Window 122
Figure 220: Load Firmware Upgrade Window 123
Figure 221: Firmware Upgrade Warning 123
Figure 222: Firmware Upgrade Process 123
Figure 223: Firmware Upgrade Successful 124
Figure 224: Firmware Upgrade Process Complete 124
Figure 225: General Device Settings 125
Figure 226: Selecting an auxiliary device 125
Figure 227: Auxiliary Device Settings 126
Figure 228: Ethernet Settings 126
Figure 229: Security Settings 126
Figure 230: Date and Time Settings 127
Figure 231: Loading a Configuration 129
Figure 232: Write Configuration warning 130
Figure 233: Writing and Device Resetting Process 130
Figure 234: Writing Complete 130
Trademarks
:
© 2014 Kramer Electronics Ltd. All rights reserved. Microsoft and Windows are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other
countries. Android is a trademark of Google Inc. iOS is a registered trademark of Apple Inc.