Kramer Electronics WP-501 - Manual (Page 52)

K-Config – The Driver Manager – Getting Started 47
Figure 81: The Driver Manager Window – Writing the Commands
Upon creation, by default, all the rows are checked – meaning that when you move UP/DN the list, all the rows will be
used. If you prefer to use less rows in your configuration (for example, you may not need to use all the volume levels to
create a clean volume UP/DN effect) You can now enable or disable specific row commands manually or through the
“Select Every” box, as needed (for example, to set the rate of increase or decrease of the volume) by selecting which
commands should be used when traveling UP/DN in the table with the relevant K-Config Action commands:
6. For example, select every 3 rows:
Figure 82: The Driver Manager Window – Selecting every 3 Rows
7. Check the Keep current selection box if required.
You can also do this logarithmically, for example, to increase the volume at a fast rate in the lower range and slower in
the higher range:

Check Logarithmic

Select the approximate number of steps you need (the table calculates the optimal number)

Click the Set button