Kramer Electronics WP-501 - Manual (Page 133)

128 K-Config - Connecting to the Device
The following table summarizes the date and time setting options:
Set Date and
Time Procedure
From a connected
PC Clock 1. Click the “Set Now” button.
2. Click Read (from device) to check the updated
values.
If you want the time and date to be set whenever writing a configuration, check “Set from PC on Write Configuration”.
Manually 1. Click the dropdown box.
2. Select the desired date and time from the
dropdown box.
3. Click the Set Now button.
4. Click Read (from device) to check the updated
values.
From a server
address 1. In the Sync Date and Time area, check “From
Server Address”.
2. Type the IP address.
For example, 192.168.0.6
3. Set the DST to ON (for adjusting the time to the
“summer” clock) if required
4. Set the time zone according to UTC.
For example, the time in Jerusalem is
UTC +2:00.
5. Click the Read (from server) button (below the
IP number).
6. Click Read (from device) to check the updated
values.
The device updated date and time appear
In case there was a problem reading the date and
time, the following message appears: