Kramer Electronics WP-501 - Manual (Page 9)

4 K-Config - Kramer K-Config Software Installation
3 Kramer K-Config Software Installation
You are here:
Configuration Steps Description Section
Introduction General information and system requirements 1
Planning Carefully plan your controlled room 2
Installation Install the Software 3
Introduction to K-Config Get to know the K-Config main window, menus and quick access icons 4
Driver Manager Define the Peripheral Device Drivers 5
Project Navigator Define the Controlled Room 6
Port Manager Assign the peripheral devices to the Master and Auxiliary device ports 7
Triggers Activate the Triggers 8
Adding Actions Describes how to add the various actions to a trigger 9
Connecting to a Device Describes how to connect to a device, upgrade the firmware, read/write to the device
and so on 10
To install the K-Config software, do the following:
 Check that “.NET Framework” Revision 4.0 software is installed or install it if it is missing (see Section 3.1 )

Install the USB driver (see Section 3.2 )

Install the Kramer K-Config software (see Section 3.3 )
3.1
Installing the “.NET Framework” Revision 2.0 Software
Prior to using the Kramer K-Config software, make sure that the “.NET Framework” Revision 4.0 software is installed
on your PC. If it is not, you need to install it:

If you have a fast Internet connection, this software is automatically installed during the installation of the Kramer
K-Config software
3.2 Installing the USB Driver
If you wish to configure the RC device by connecting it via a USB cable, you need to download and install the USB
driver. Download the Kramer USB driver from the installation disc or from our Web site at
http://www.kramerelectronics.com/support/downloads.asp , save it on your PC and extract the zip file to a directory
where you can find it later.
Connect the mini USB cable from your PC to the device and wait until Windows 7 completes the connection and will
report in a bubble that "Device driver software was not successfully installed" (If the device driver is installed
successfully, skip the rest of section).
Figure 2: USB Driver Installation –USB Installation Attempt