Kramer Electronics WP-501 - Manual (Page 60)

K-Config – Defining the Control Room via the Project Navigator 55
Figure 91: The Action Editor for RC-74DL and RC-63DL
4. In the Project Navigator area, select 1 - RC-74DL.
It is necessary to select the Master controller to add an additional device
5. Click +.
6. Select another device from the list (for example, the RC-13TC).
To add additional auxiliary devices (depending on the Master RC selected, up to four Aux K-NET devices
and two Virtual Devices can be used in the same control setup), repeat the above steps.
Be sure that your control room setup tree is correct before continuing with the configuration. If, at a later
stage, an auxiliary K-NET device or a Master RC will be deleted from the tree, all the port assignments,
triggers and action lists written for all the devices in the tree will also be deleted.
You can right-click a device to carry out several operations, as illustrated in the examples in the table below:

Add a device (Master RC only)

Delete a device

Add a description that will appear in the Device View area

Upgrade the firmware (via master RC)

Set the K- NET™ ID (see Section 10.2 )

Edit the device view (virtual device only)

If the setup includes two or more identical AUX panels – you can set some of them to be the “exact same as”
another AUX/Master device (so they will behave in the exact same manner)

Export a device (for virtual devices only)
i
i