Figure 83: the driver manager window, Logarithmic row selection, Figure 84: the driver manager window – Kramer Electronics WP-501 User Manual
Page 53: Setting the led levels
48
K-Config - The Driver Manager
– Getting Started
Figure 83: The Driver Manager Window
– Logarithmic Row Selection
8.
Set the LED Level:
Figure 84: The Driver Manager Window
– Setting the LED Levels
The Levels indicate the number of digital knob LEDs that light for each data command on relevant controllers
(for example, the RC-63DL or RC-54DL). You can set the LEDs to light only in sequence. For example, one
LED will light for data commands up to 30. Two LEDs will light up to data command 50, and so on.
Note that when selecting a command, the test command area appears, letting you test each command in the
table.
9.
When the table is complete, click the Apply Table Changes button and then click OK.
You can create several sets of tables for different commands.
Once the table is ready, you can use the commands table to set the volume to an exact value in a trigger
(see
).
i