Kramer Electronics WP-501 - Manual (Page 134)

K-Config – Connecting to the Device 129
10.5 Syncing the Configuration to the Device
Once the configuration is ready, you can sync (write) it to the device, by selecting Sync Configuration to Device from
the Device menu list.
Note that:

In Master-Auxiliaries configurations, the configuration file is always written to the Master

When using a standalone room controller, the configuration file is written to the room controller
In case you have written a configuration file to a device and it is now connected as an auxiliary device to another
master, you have to define the device as an auxiliary device and upload an updated configuration file to the Master.
Before writing the configuration to the device you have to save it as a project.
To write a configuration to the device, do the following:
1. Connect the PC to the Master or the standalone room controller via the Ethernet/RS-232/USB.
2. Click the Connect button (or select Connect from the Device menu list).
3. In the Device menu, select Sync Configuration to Device (or click the Sync to Device button on the top
right).
You will be prompted to save the configuration as a project:
Figure 231: Loading a Configuration
4. If required, change the file name and then click Save.
The Write Configuration warning appears: