Kramer Electronics WP-501 - Manual (Page 67)

62 K-Config - Assigning the Peripheral Devices to Master and Auxiliary Device Ports
7 Assigning the Peripheral Devices to Master and Auxiliary Device Ports
You are here:
Configuration Steps Description Section
Introduction General information and system requirements 1
Planning Carefully plan your controlled room 2
Installation Install the Software 3
Introduction to K-Config Get to know the K-Config main window, menus and quick access icons 4
Driver Manager Define the Peripheral Device Drivers 5
Project Navigator Define the Controlled Room 6
Port Manager Assign the peripheral devices to the Master and Auxiliary device ports 7
Triggers Activate the Triggers 8
Adding Actions Describes how to add the various actions to a trigger 9
Connecting to a Device Describes how to connect to a device, upgrade the firmware, read/write to the device
and so on 10
The Port Manager window lists the ports on the selected K-NET device (Master RC or Aux K-NET device) or
standalone room controller and lets you write a description and assign a default driver to each port.
Note that ports on auxiliary devices can be used only for sending outgoing commands from the auxiliary
device to an AV device. If you need to use Monitor Event triggers or Queries functions, which rely on
bidirectional communication, connect the AV device to the K-Net master device. For similar reasons, GPI/O
ports on the auxiliary devices will be disabled.
In the following example, the project navigator includes the RC-74DL, the RC-63DL, the RC-53DLC and the SL-10,
see Figure 101 .
Figure 101: The Control Room Example
To set the ports of the Master device (for example, RC-74DL):
1. Select 1-RC-74DL in the Project Navigator area.
2. In the Windows menu, select Port Manager.
Figure 102: Select the Port Manager
i