Agilent Technologies 01664-97005 - Manual (Page 13)

Measurement and Display Functions
Displayed Waveforms 24 lines maximum, with scrolling across 96 waveforms.
Measurement Functions
Run/Stop Functions Run starts acquisition of data in specified trace mode.
Stop In single trace mode or the first run of a repetitive acquisition, Stop halts
acquisition and displays the current acquisition data. For subsequent runs in repetitive
mode, Stop halts acquisition of data and does not change the current display.
Trace Mode Single mode acquires data once per trace specification. Repetitive mode
repeats single mode acquisitions until Stop is pressed or until the time interval between
two specified patterns is less than or greater than a specified value, or within or not within
a specified range.
Indicators
Activity Indicators Provided in the Configuration and Format menus for identifying
high, low, or changing states on the inputs.
Markers Two markers (X and O) are shown as vertical dashed lines on the display.
Trigger Displayed as a vertical dashed line in the Timing Waveform display and as line 0
in the State Listing display.
Data Entry/Display
Labels Channels may be grouped together and given a 6-character name. Up to
126 labels in each analyzer may be assigned with up to 32 channels per label.
Display Modes State listing, State Waveforms, Chart, Compare Listing, Compare
Difference Listing, Timing Waveforms, and Timing Listings. State Listing and Timing
Waveforms can be time-correlated on the same displays.
Timing Waveform Pattern readout of timing waveforms at X or O marker.
Bases Binary, Octal, Decimal, Hexadecimal, ASCII (display only), Two’s Complement,
and User-defined symbols.
Symbols 1,000 maximum. Symbols can be downloaded over RS-232 or GPIB.
General Information
Supplemental Characteristics
1–5