Agilent Technologies 01664-97005 - Manual (Page 14)

Marker Functions
Time Interval The X and O markers measure the time interval between a point on a
timing waveform and the trigger, two points on the same timing waveform, two points on
different waveforms, or two states (time tagging on).
Delta States (state analyzer only) The X and O markers measure the number of
tagged states between one state and trigger or between two states.
Patterns The X and O markers can be used to locate the nth occurrence of a specified
pattern from trigger, or from the beginning of data. The O marker can also find the nth
occurrence of a pattern from the X marker.
Statistics X and O marker statistics are calculated for repetitive acquisitions. Patterns
must be specified for both markers, and statistics are kept only when both patterns can be
found in an acquisition. Statistics are minimum X to O time, maximum X to O time,
average X to O time, and ratio of valid runs to total runs.
Auxiliary Power
Power Through Cables1/3 amp at 5 V maximum per cable
Operating Environment
Temperature Instrument, 0
°C to 55 °C (+32 °F to 131 °F).
Probe lead sets and cables,
0
°C to 65 °C (+32 °F to 149 °F).
Humidity Instrument, probe lead sets, and cables, up to
95% relative humidity at +40
°C (+122 °F).
Altitude To 4600 m (15,000 ft).
Vibration Operating: Random vibration 5 to 500 Hz,
10 minutes per axis,
≈0.3 g (rms).
Non-operating: Random vibration 5 to 500 Hz,
10 minutes per axis,
≈ 2.41 g (rms);
and swept sine resonant search, 5 to 500 Hz,
0.75 g (0-peak), 5 minute resonant dwell
at 4 resonances per axis.
Dimensions
General Information
Supplemental Characteristics
1–6