Hale 80FC - Manual (Page 117)

117 Pump Ends
p/n: 029-0020-61-0
G ea rb o x R ep air
❑
Figure 6c-1: 20 / 30 FS Series Gearbox and Bell Housing Overview
3. Slide the unit straight back to remove the splined drive shaft from the engine
mount and drive disk (SAE #8 or SAE #10). Place and support the assem-
bly on a suitable work area.
Note: If required, remove the eight (8) 3/8”-16 screws and washers securing the drive
disk to the engine mount. Examine, repair and/or replace the rubber disks as
required. When a disk is to be replaced it is advisable to replace ALL disks as a set.