Hale 80FC - Manual (Page 13)

13 Pump Ends
p/n: 029-0020-61-0
Saf ety
❑
Eye Protection required when operating equipment
Flammable Fuel Hazard
Hearing Protection required when operating equipment
Hot Surfaces Hazard
1.2 GENERAL
Read all instructions, including the Engine Manufacturer’s Operating
and Maintenance Manual, thoroughly before beginning
any installation, service or operation process.
❑ Use care when removing the pump assembly from its packaging to pre-
vent personal injury and/or damage to the system.
❑ Use all mounting bolt holes provided on the gearbox, pedestal and/or the
pump to support the assembly. See the appropriate assembly plate
drawing, located at the back of this manual, for additional installation
information.
❑ Installation should be performed by a trained and qualified installer, such
as your authorized Hale representative. Be sure the installer has suffi-
cient knowledge, experience and the proper tools before attempting any
installation.
WARNING !
THE HALE PUMP ENDS, GEARBOX OR PEDESTAL ASSEMBLIES (IF
INCLUDED) CAN BE HEAVY AND BULKY. ADDING ACCESSORIES TO THE
SYSTEM ALSO INCREASES THE WEIGHT. CHECK YOUR BILL OF LADING
FOR THE APPROXIMATE WEIGHT.
BE CERTAIN TO USE PROPER LIFTING SUPPORT DEVICES (I.E., OVER-
HEAD CRANE, JACKS, CHAINS, STRAPS, ETC.) CAPABLE OF HANDLING
THE LOAD WHEN REMOVING OR INSTALLING THE HALE PUMP END
ASSEMBLY.