Hale 80FC - Manual (Page 83)

83 Pump Ends
p/n: 029-0020-61-0
Co rr ec tive M ain te n an ce
❑
4. Lightly oil or grease the shaft, O-ring seals and lip seals with a coating
of general-purpose grease before reinstalling, especially when pressed-
in.
5. For Hale recommended cleaners, see “Appendix C1: Lube and Sealant
Specifications” on page 139.
6. Replace any hardware that shows signs of excessive wear.
Bearings
Bearings and other components should be cleaned using only recom-
mended solvents.
Bearings must always be replaced in matching sets by manufacturer.
IMPORTANT !
WHEN REPLACING TAPERED BEARINGS, IT IS IMPORTANT THAT YOU DO
NOT INTERCHANGE BEARING MANUFACTURER’S COMPONENTS. THE
BEARING RACE AND CONE MUST ALWAYS BE REPLACED IN MATCHING
SETS, AS SUPPLIED BY THE MANUFACTURER.
Tools Required
❑ Lifting gear-lever hoist or chain hoist, and short choker
❑ Ball peen hammer
❑ Center punch
❑ Drift punch
❑ Allen wrenches
❑ Strap wrench
❑ Snap ring pliers
❑ Pry bars (2)
❑ Ratchets and wrenches for disassembly
❑ Torque wrench capable of 40, 65, and 135 ft.-lbs. (54, 88, and 183 N-m)
❑ Pan (to collect drip oil)