JLG 3246ES Service Manual - Manual (Page 121)

SECTION 5 - JLG CONTROL SYSTEM
3121166 – JLG Lift – 5-1
SECTION 5. JLG CONTROL SYSTEM
5.1 HAND HELD ANALYZER
To Connect the Hand Held Analyzer:
1. Connect the four pin end of the cable supplied
with the analyzer, to the diagnostic port (refer
toSection 3.1) and connect the remaining end of
the cable to the analyzer.
NOTE: The cable has a four pin connector at each end of the
cable; the cable cannot be connected backwards.
2. Power up the Control System by turning the lower
key to the platform position and pulling both
emergency stop buttons on.
men u:
PRESS ENTER HELP:
Analyzer Display
Escape Key
To return home or
access previous menu
Enter Key
Stores and selects Top Level, Sub Level,
and item menus
Left & Right Arrow Keys
Used to move between Top Level, Sub
Level, and item menus
Up & Down Arrow Keys
Value Selector
Figure 5-1. Hand Held Analyzer