JLG 3246ES Service Manual User Manual
Page 87
SECTION 3 - CHASSIS & SCISSOR ARMS
3121166
– JLG Lift –
3-51
USA Built Machines S/N 0200170585 to Present &
Belgium Built Machines S/N 1200015159 to Present:
NOTE: The below procedures (1 - 19) apply to 1930ES only.
CAUTION
BE SURE TO PULL THE BATTERY DISCONNECT ANYTIME WORK IS
BEING PERFORMED ON THE DRIVE MOTORS OR DRIVE MOTOR
CABLING.
1.
Orient the drive cables going back towards the
rear of the machine as shown below.
2.
Loop the cables forward towards the front of the
machine then up and back so that the clamping
rings on the cables are aligned together.
3.
Obtain the Cable Clamp and hardware.
15.
Place the Green Clamp on the clamping rings as
shown below.
16.
Bolt the clamp onto the underside of the frame.
a. The Spacer goes between the frame and the
Clamp.
b. Place the Larger Washer against the clamp.
17.
Connect the drive motor cables to the power mod-
ule.
18.
Tuck all wires into the power module compart-
ment and install cover.
19.
Reconnect battery cable plug. Power up machine
and operate the drive function to ensure drive
motors operate properly.
1.
Cable Clamp
2.
Spacer Plate
3.
Capscrew, Washers, and
Nut
1
3
2
1
1.
Drive Cables
2.
Cable Clamp
3.
Spacer Plate