Caron 6017 - Manual (Page 41)

6010 Series Operations Manual Rev E 2/14/2012 Page 41 of 68
Operating the timer
The power switch enables and disables the lights and cycle timer. When the timer is
“on”, the 2 nd set-point (also known as “idle set point”) on the controllers is enabled as
well as the lights. The timer will display “OUT” corresponds to lights being enabled. The
timer has an adjustable “on” and “off” cycle times which repeat continuously. SET1
corresponds to the lights “on” cycle time and SET2 to the lights “off” cycle time.
Setting the cycle timer
1. With the Light Power Switch ‘on’, press the MODE button until SET1 is displayed
2. Using the up and down cycle time adjustment buttons, set the lights ‘off’ cycle
timer to the desired time in the format hh:mm. Maximum time is 99hrs 59min.
3. Press the MODE button; cycle time display indicator switches to SET2.
4. Using the up and down cycle time adjustment buttons, set the lights ‘on’ cycle
timer to the desired time in the format hh:mm. For continuous lights ‘on’ operation,
set the SET2 cycle time to 00:00. Maximum time is 99hrs 59min.
Press the RESET button to reset the timer so it starts at the beginning of the lights off
cycle.
Press the MODE button to toggle between lights on (SET1) and lights off (SET2) times
MODE
button
Cycle Time on
(or off)
Cycle time
adjustment buttons
RESET
button
Cycle time
display indicator
Lights on
status indicator
Present
accumulated time